SecKit/Pallet 2 frame mount

This allows the Pallet 2/2S to hang off the side of your SK-GO printer between the front post and the middle post, using the included wall mount with the Pallet. Print this out, bolt the wall-hanger onto the adapter, then use some M4 bolts + T-nuts to hold it in place. This member is under quite a bit of stress so I decided to go overkill and print at 100% infill, I'm sure you could get away with less. If you go with less, do it at your own risk...Pallets are not cheap if they fall and break. Also, make sure those bolts + T-nuts are properly engaged and tight for the same reasons.