Thingiverse
Secure Filament Clip - 1.75
by pixel2
322
Downloads
174
Likes
2
Makes
Update 9/2019 - Filament snaps into the clip with greater holding power.
Wedge the first loop into the lower slot. Use a finger on each side of the clip to snap the end into the upper channel leaving about 5cm of slack. Pinch the filament behind the clip and push towards the loose end. Things should be nice and secure.
Wedge the first loop into the lower slot. Use a finger on each side of the clip to snap the end into the upper channel leaving about 5cm of slack. Pinch the filament behind the clip and push towards the loose end. Things should be nice and secure.
pixel2 also publishes on
28 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!