Security Cam Night vision upgrade

1/26/19 - currently prints and fits LED's. Print upside down, should print no problem. I am printing one right now.

****IMPORTANT... PRINT FACE DOWN! The model is face up here so you can see what it looks like, but it is designed to be printed face down so that support is not needed.

This is not a true remix per say. The part is my original, but it is an add on / upgrade part for the Raspberry Pi Zero W security Camera.

I was going to design my own housing for a security cam, but the Raspberry Pi Zero W security Camera was so good I don't need too. However it only uses 1 IR emitter for night vision, which will work fine in a small room inside, but I want a bit more for a cam that will be outside.

You put 7 5mm IR emitters and 1 light sensor, wire it in the back, and run the hook up wire through the holes that were for the single emitter and sensor.

Use longer screws to attach the IR adapter through the front piece and to hold it together.