MakerWorld
Other Hobby & DIY
Zum Modell
Security Camera CX810 Cover
6
Downloads
1
Likes
2
Makes
I planned to install some Reolink CX810 cameras outside and without any natural cover, so naturally I designed a cover that might help shield it from the sun and rain. It has holes for venting that should hopefully be small enough to keep bugs out. This snaps into place as you slide it over the back pivot mount. Then slide the cover a little forward to till it is seated fully. Print it using PETG, or even high-temp PLA if you plan on painting it. ASA was too brittle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
