Slicer Discord
Seed Starter - Single Large Pot – 3D-Druckmodell von MakerWorld MakerWorld
Garden

Seed Starter - Single Large Pot

24 Downloads
10 Likes
13 Makes
Zum Modell
This is a larger seed starter pot to round out the collection of self-watering seed starter pots I have linked below. This is a large, single-plant pot that can be coupled with my seed-starter trays, including the new 2x2 127mm tray, that can hold up to 9 of these large single pots. These have 4 small drainage holes on the base, along with a larger center hole to be used with the plunger to help push up the dirt when it's time to transfer your plants to your garden beds. These units are built very robust to stand up to years of use and re-use. These are also stackable to help with storage in off-seasons. These can also be used on incubation pads if needed, so the base has been built thicker to withstand the heat and not deform or warp over time. Feel free to adjust the thickness though if desired with the attached STEP file. This setup is part of a larger series of designs I made for your plant starting adventure.Small self-watering starters to begin your initial starts can be foun
Kategorie
Garden
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen