Slicer Discord
SeedPot – Modelo 3D imprimible de Thingiverse Thingiverse

SeedPot

19 Descargas
16 Likes
0 Makes
Ver Modelo
A little two piece planter I designed to help facilitate the movement of seedlings into larger planters for better root development. Plenty of holes on the inner ring for proper drainage and larger holes in the outer planter to assist. When the seedlings are ready to be moved, simply allow the soil to dry just a little so that it pulls away from the inner ring a bit, remove the outer ring and sit the plant into the transplanting container, preferably with a lining of mycorrhizae, then gently push the seedling down while pulling the ring up to plant perfectly, then backfill for support. If used properly, transplants are a breeze. It is very important that the seedling is removed before it grows through the pot, to minimize damage during transplanting. the whole idea is to get it out of this pot easily, excessive growth defeats the purpose of this pot. Good luck and happy gardening. Stay Kind.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Cama mín.
50 mm (Pequeño)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección