Seestar EQ Wedge

I changed the awesome design that Lordwhiteley did so that I could use the hardware I had in the shop.
You'll need some 1/4" bolts and three nuts, a 3/8" bolt for the Seestar and a 3'8" nut for the base mount. I'd use all stainless if you can.
The 1/4" bolt that goes into the elevation adjuster needs to have the points ground off into a circle so it spins in the elevation pivot, then glue the cap on.
You'll need to experiment with your elevation bolt length a bit, I think I used a 3" one up here in Oregon at 45 degrees.