Self-Watering planter

Self-watering planter is easy to print and uses a small amount of plastic. It was printed in PLA although PETG is preferred. The top has a small hole, so sip water out into the pot. make sure it's deep enough. The part can be scaled to fit your size. Only check the small hole to see if it's still there or a hot needle to fix the issue. The model uses a small brim inside the big hole and can be removed easily. I used a deburring tool to make it easy to remove. After some feedback the walls are changed to 2mm so there are no gaps anymore in the back of the model. You can still download the old V1 version if you wanna safe on filament and get use a small layer height.