Thingiverse
Sensor Case with Lid for LED Module (Keyestudio)
door HeliconOne
2
Downloads
1
Likes
0
Makes
This is a case for Keyestudio sensors/modules, 20x31 mm. This design is for LED-modules.
The lid has a snug fit and closes well. (The sensor/module is also with a snug fit but if you want to feel more secure you can add a small piece of dubble-sided tape on the underside of sensor/module.)
There are two versions for the lid: One with just a plain hole for the LED and another with a hole and "reflector".(The latter need supports to be printed properly.
The lid has a snug fit and closes well. (The sensor/module is also with a snug fit but if you want to feel more secure you can add a small piece of dubble-sided tape on the underside of sensor/module.)
There are two versions for the lid: One with just a plain hole for the LED and another with a hole and "reflector".(The latter need supports to be printed properly.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
