Thingiverse
Sensor Community Case
door goodsam
2
Downloads
6
Likes
0
Makes
Hello,
I’ve just finished designing and printing an outer case, as I couldn’t find a suitable model.
I voluntarily left aside the NodeMCU ESP8266 which will remain warm and will be connected to the external box via a RJ-45 cable.
There are two shrinkages on the inside of the cover, one on the left and the other on the right, so that a mosquito net can be glued on.
The main Rj45 cable comes from the bottom of the box.
the DS011 Fine dust sensor is inserted on the right,
the BME280 6-PIN is positioned upper left.
I’ve just finished designing and printing an outer case, as I couldn’t find a suitable model.
I voluntarily left aside the NodeMCU ESP8266 which will remain warm and will be connected to the external box via a RJ-45 cable.
There are two shrinkages on the inside of the cover, one on the left and the other on the right, so that a mosquito net can be glued on.
The main Rj45 cable comes from the bottom of the box.
the DS011 Fine dust sensor is inserted on the right,
the BME280 6-PIN is positioned upper left.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
