Sensorless EndStop Dummy M8

This is a dummy sensorless endstop, commonly used when you install sensorless drivers like TMC2209 / TMC2226.

If you don't want complicate with Marlin setup (X_MIN_POS / Y_MIN POS) this part could be that you need.

Simply aling the nozzle with the bed edge and then, put the dummy sensorless endstop in the X axis (M8) aginst X carriage. (See the picture)
It can be using in Y axis too.

Tighten the screws...
BE CAREFUL!!... tighten the screws uniformly whit moderatly pression to avoid part cracking... you olny need that it dosen't move.

You need 2 M3x12 Screw and 2 M3 Nut.

Plese share if you print it...

Pura vida!!