Thingiverse
Serenity Logo Coaster
von SFLeBrun
43
Downloads
22
Likes
0
Makes
A drink coaster with the Serenity Logo from the television show Firefly and movie Serenity.
The coaster is 100 mm in diameter and 5 mm thick.
The initial version of this coaster was missing the "i" in Serenity. Version 2 has the correct spelling. The version 1 files have been removed and replaced with the V2 files.
In the photos there are two actual printed coasters. The purple one was sliced with PrusaSlice using Hilbert Curve for the top layer pattern. The blue one was sliced with Cura using Lines for the top layer pattern. Personally, I prefer the Hilbert Curve finish though both work fine as coasters.
The coaster is 100 mm in diameter and 5 mm thick.
The initial version of this coaster was missing the "i" in Serenity. Version 2 has the correct spelling. The version 1 files have been removed and replaced with the V2 files.
In the photos there are two actual printed coasters. The purple one was sliced with PrusaSlice using Hilbert Curve for the top layer pattern. The blue one was sliced with Cura using Lines for the top layer pattern. Personally, I prefer the Hilbert Curve finish though both work fine as coasters.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
