Thingiverse
Seriously another prusa spool mount
von kellesabelle
0
Downloads
1
Likes
0
Makes
I know there are plenty of these out there, but here's what I wanted:
Mounted on the Prusa: I didn't want to drill holes in my walls, and desk space is at a premium for now.
Low friction or otherwise set it and forget it-ish: The best success I had previous to this was leaving the spool on its side on the floor. I had to check it from time to time but it usually worked out OK.
So really, nothing too crazy. This is what I came up with. It attaches to the z-mount instead of the regular clamp. Works like a champ.
Mounted on the Prusa: I didn't want to drill holes in my walls, and desk space is at a premium for now.
Low friction or otherwise set it and forget it-ish: The best success I had previous to this was leaving the spool on its side on the floor. I had to check it from time to time but it usually worked out OK.
So really, nothing too crazy. This is what I came up with. It attaches to the z-mount instead of the regular clamp. Works like a champ.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
