Thingiverse
Sermoon D1 CR Level Mount
by FLmakers
3
Downloads
2
Likes
0
Makes
Massively reinforced to deal with the epic failure in design of the Sermoon D1 printer.
Mounting screws are deliberately set slightly wide it means the screws will bind in the CR-touch probe and hold it solid, but then when its done measuring you can remove it and hang it over the cables so it doesn't destroy itself on the first run.
Mounting screws are deliberately set slightly wide it means the screws will bind in the CR-touch probe and hold it solid, but then when its done measuring you can remove it and hang it over the cables so it doesn't destroy itself on the first run.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!