Thingiverse
Sermoon D1 Inclosure
von Ter_Z
11
Downloads
9
Likes
0
Makes
I desinged this to make a top enclosure for my Sermoon D1.
This enclosure requires these additional parts：
1 Top panel: 432mm x 432mm x 6mm
2 Front panel: 432 mm x 120 mm x 6mm
2 Side panel: 420mm x 120 mm x 6mm
（It is recommended to use a panel made of PC material）
The file contains some components that used to let filament pass through the sheet and a part to hang the wire.
When connecting to the inclosure to 3D printer, please do not use the M3 copper column, just fix it directly. If you are not sure, just look at the pictures.
It is recommended to use “M3 x 4 x 5 hot melt nset nuts”.
This enclosure requires these additional parts：
1 Top panel: 432mm x 432mm x 6mm
2 Front panel: 432 mm x 120 mm x 6mm
2 Side panel: 420mm x 120 mm x 6mm
（It is recommended to use a panel made of PC material）
The file contains some components that used to let filament pass through the sheet and a part to hang the wire.
When connecting to the inclosure to 3D printer, please do not use the M3 copper column, just fix it directly. If you are not sure, just look at the pictures.
It is recommended to use “M3 x 4 x 5 hot melt nset nuts”.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
