Thingiverse
Server 24 drive JBOD - Modular Design
por Schlomorific
40
Descargas
34
Likes
0
Makes
**Included a "Drive Test" STL to test tolerances on your specific printer.**
Print with something other than PLA as the warm drives will warp it.
Each section will use about 1 full 1kg spool of filament, depending on infill.
Drive tolerance is tight, so depending on printer you may need to scale up by 1% or so.
Use PCI riser to give power to your SAS Expander, and a zIp tie to keep the PCI card in the slot (No screws).
Fan slots are for 92mm fans.
Print with something other than PLA as the warm drives will warp it.
Each section will use about 1 full 1kg spool of filament, depending on infill.
Drive tolerance is tight, so depending on printer you may need to scale up by 1% or so.
Use PCI riser to give power to your SAS Expander, and a zIp tie to keep the PCI card in the slot (No screws).
Fan slots are for 92mm fans.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
