Servo Control Horn

This is a servo control horn based on SPONZ's control horn. It's similar in size to the FT control horn and SPONZ's, I completely redrew it in FreeCAD with tabs that extend through the board and base plate. The holes in the tabs are there so you can lock in the base plate with a bead of hot glue. The base plate is there to reduce the chances of the control horn pulling out of the foam.

Currently there are two sizes:
1.7mm- fits wire 1.2mm in diameter
2mm- fits wire 1.6mm in diameter

I will probably add more options with different diameter holes to fit different hardware as the need arises.

SPONZ's Control Horn- https://www.thingiverse.com/thing:3094387