Servo Tester Case - for mount inside box

This case for servo tester was designed for my mini-lathe. I have to replace old controller with new one that includes servo tester instead of ordinary potentiometer.

More details how to assemble case:
https://youtu.be/8adNPPK4yI4

And about motor, controller and servo tester can be seen on:
https://youtu.be/BadXx8bJlnk

All bolts and nuts used for assembling are 3mm:
- 23mm and 13mm (thread length) for mounting cover and bottom
- 17mm and 14mm (thread length) for mounting to the mini-lathe control box
- 4 nuts (two for attaching to the case and two for mounting PCB inside upper and bottom part)

Cover and potentiometer extender should be rotated for 180 degrees before print. In this case support is needed only for printing small foot on cover part.