Thingiverse
Setup Wheel 62mm V3.1
door opulius
47
Downloads
22
Likes
1
Makes
#Setup Wheel 62mm V3.1
#This file has moved: https://www.prusaprinters.org/prints/98493-setup-wheel-62mm-v31
With these 62mm setup wheels you can setup the ride height, camber and front toe on your 1/10 RC touring car very easy and precise. Use a 2x60 mm rubber O-ring in the outer rim to reduce the risk of damage to your setup board.
With the O-Ring Mounted the diameter is around 63mm
If you want you can support my hobby by clicking the affiliate link to the O-rings
Have Fun
https://www.prusaprinters.org/social/62816-opulius/about
See my Instagram account:
https://www.instagram.com/0pulius/
And if you like my design please don't forget to share in instagram #opulius :-) This helps a lot!
#This file has moved: https://www.prusaprinters.org/prints/98493-setup-wheel-62mm-v31
With these 62mm setup wheels you can setup the ride height, camber and front toe on your 1/10 RC touring car very easy and precise. Use a 2x60 mm rubber O-ring in the outer rim to reduce the risk of damage to your setup board.
With the O-Ring Mounted the diameter is around 63mm
If you want you can support my hobby by clicking the affiliate link to the O-rings
Have Fun
https://www.prusaprinters.org/social/62816-opulius/about
See my Instagram account:
https://www.instagram.com/0pulius/
And if you like my design please don't forget to share in instagram #opulius :-) This helps a lot!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!