Sewing Machine Thread Holder

** October 20 2021 **
Added updated Bobbin wheels of varying sizes based off https://www.thingiverse.com/thing:2875543


** Original **
Remixed to reduce the printing time and plastic used by almost 50%.

Original would take approximately 16hrs and use 138g (0.3lb) of filament
New would take approximately 8 1/2hrs and use 76g (0.7lb) of filament

There are 2 version of the horizontal rod holder as I did not have enough 6mm rod. Large size takes 6mm rod, small size take 3/16” (roughly 4.8mm) rod

Also 2 version of the Bobbin Wheel, large diameter takes 6mm rod, the other takes 3/16” (roughly 4.8mm) rod

1 x Central rod 8mm x230mm (longest I had)
2 x horizontal rods 3/16 x 200mm
4 x vertical rods 6mm x 40mm

Print
4 x Petal
2 x Horizontal Brace
Depending on your preference
4 x Cone Holder and 8 x Bobbin wheel
or
12 x Bobbin wheel

The Cone holders are designed to fit overlock thread 'cones' which are much cheap