Thingiverse
SFIC Holder
von translucent1
15
Downloads
3
Likes
0
Makes
A simple slip fit holder for 6 or 7 pin SFICs. There's no retention for the control lug so you can just push out the lock when you're done.
This is designed to be a snug fit so you may need to experiment with scaling up or down by a fraction of a percent to get a perfect fit.
This is designed to be a snug fit so you may need to experiment with scaling up or down by a fraction of a percent to get a perfect fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
