Thingiverse
ShadowHunters Insert Remix
von aymaliev
0
Downloads
3
Likes
0
Makes
This is a remix. Here are the changes to the original design:
- Everything is 33mm high (3mm lower than the original 36mm) to allow the game board to fit into the box.
- The card trays are wider and deeper to allow for sleeved cards.
- The card trays have deeper side opening for easier card pickup.
- Uses less material and prints faster. I also suggest 10% infill, which is quite enough.
- Everything is 33mm high (3mm lower than the original 36mm) to allow the game board to fit into the box.
- The card trays are wider and deeper to allow for sleeved cards.
- The card trays have deeper side opening for easier card pickup.
- Uses less material and prints faster. I also suggest 10% infill, which is quite enough.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
