Thingiverse
Shampoo holder
von hallonhatt
14
Downloads
31
Likes
0
Makes
A holder for two large (ø ~92mm ) shampoo and conditioner bottles to be squeezed onto two 12mm pipes.
When I finished the design I realized it would require a lot of support material to print but I had lost interest in this model at that point so I just printed it that way. Be aware of this if you are going to print it (see pictures)
When I finished the design I realized it would require a lot of support material to print but I had lost interest in this model at that point so I just printed it that way. Be aware of this if you are going to print it (see pictures)
hallonhatt veröffentlicht auch auf
19 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
