Shape-O Shapes

My mum found an old Shape-O from Tupperware that I LOVED as a kid. My sister's (almost) 1 year old is staring to get into these kind of toys, so mum pulled it out of the cupboard, but there were some shapes missing. So I've gone ahead and created the replacement shapes for it, in case you're missing one or two!

Printing:
Start off the first layers slowly my usual print speed is about 50mm/s and I chose about 40% speed for the first layer - this helps them stick, as there are some sharp corners on some of them and I noticed for some, the first layer just wasn't sticking... If all else fails, the trusty glue stick works.

Make sure you use support for the hollow bottoms of each shape.