Thingiverse
Shapeoko bit catcher tray
por ex-nerd
21
Descargas
7
Likes
0
Makes
The Shapeoko moves out over the front of the machine for bit changes, which has led to more than a few bits falling to the ground and breaking. This little tray clips onto the front of the machine to catch any bits that might slip out of the collet and fall.
Designed to print at an angle so no supports are needed. Depending on how sticky your bed is, you may need a brim.
Designed to print at an angle so no supports are needed. Depending on how sticky your bed is, you may need a brim.
ex-nerd también publica en
73 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
