MakerWorld
Jewelry
Go to Model
Shark Bowl
95
Downloads
103
Likes
45
Makes
I see these cute Shark Bowls in Ceramic all the time. So I figured I'd try and model one in Blender. I ran a few test prints before trying a Multicolor print. The TPU on the far right of the picture of 3 had some stringing, I don't print TPU I had a roll of it forever. If I ran the TPU again I would Lower the infill of to 15 percent
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
