Shark Rocket Vacuum Accessory Bracket - 40mm

This bracket holds the two most useful vacuum accessories – the brush and the cone – in a handy spot on the vacuum's main post, attached by a friction fit. The holes for the accessories are ~40mm in diameter; some of the accessories are 39mm but should fit, although loosely. I've tested it in PLA and PETG. Both snapped onto the post perfectly. No supports are needed.To install: Snap the middle bracket hole onto the main post. To keep the bracket from sliding down the post, I suggest a bit of rubber cement just under the bracket… as this wears off, just refresh the glue.To adjust it: feel free to remix for your diameters, if they differ – just adjust the diameter constraint in Fusion 360 of either post hole. You can change the text manually, or use use ParametricText, which is a super-awesome free add-in for Fusion that reads parameters (like the cutout's 100 degree angle) and embosses those values directly onto the model; I use this to emboss the version number on each 3D p