Thingiverse
Sharpie Highlighter Stand
door Ratty_Ma_Hatty
5
Downloads
6
Likes
0
Makes
This is a stand for holding (UK) 4x 'Sharpie Fluo XL' highlighters.
I printed in Cura with tree supports it was printed with the holes at the top to hide the rough underside.
I would recommend printing this with lots of walls and high infill so as to increase the weight so the highlighters are a little easier to remove.
The pen cap is not captured by the holder, the high lighters just drop in and are lifted out.
I printed in Cura with tree supports it was printed with the holes at the top to hide the rough underside.
I would recommend printing this with lots of walls and high infill so as to increase the weight so the highlighters are a little easier to remove.
The pen cap is not captured by the holder, the high lighters just drop in and are lifted out.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
