Thingiverse
Sharps Box
von Null_Hypothesis
12
Downloads
2
Likes
0
Makes
This is a Sharps Disposal Container/Bin.
It is designed to hold used blades with dimensions of 40x25x1mm or less.
There are two versions: one with and one without the Bio-Hazard warning symbol.
I recommend printing in "clear" PLA as it will allow you to see through the box so you can tell when it is getting full.
The box should use about 8g of PLA and takes just over an hour to print with 0.2mm layer height. It can also be printed in any orientation except on the two faces with the hazard symbols.
It is designed to hold used blades with dimensions of 40x25x1mm or less.
There are two versions: one with and one without the Bio-Hazard warning symbol.
I recommend printing in "clear" PLA as it will allow you to see through the box so you can tell when it is getting full.
The box should use about 8g of PLA and takes just over an hour to print with 0.2mm layer height. It can also be printed in any orientation except on the two faces with the hazard symbols.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
