Thingiverse
Shavette / straight razor
door ComradeMax
122
Downloads
135
Likes
0
Makes
Hello there shaving enthusiast!
No matter if this is your first time wanting to try a straight razor / shavette or you just want to have a novel razor. This print should finish in about two hours with a layer height of 0.15mm, costs only a few cents, and is a perfectly usable straight razor with changeable 42mm razor blades. The blades are hold by four strong neodymium magnets which guarantee a safe shave!
Except a printer you will need:
- Something to remove the support material
- 4x 5x2mm neodymium magnets
- A bit of superglue or epoxy
- A 42mm razor blade ( a double edged razor blade snapped in half)
- Maybe a bit of sandpaper
No matter if this is your first time wanting to try a straight razor / shavette or you just want to have a novel razor. This print should finish in about two hours with a layer height of 0.15mm, costs only a few cents, and is a perfectly usable straight razor with changeable 42mm razor blades. The blades are hold by four strong neodymium magnets which guarantee a safe shave!
Except a printer you will need:
- Something to remove the support material
- 4x 5x2mm neodymium magnets
- A bit of superglue or epoxy
- A 42mm razor blade ( a double edged razor blade snapped in half)
- Maybe a bit of sandpaper
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
