Shaving Station

Just a simple shaving station to hold a razor, two bottles/tubes, and a cartridge of blades.
If you don't use DSC then I have some dimensions for the holders.

Razor cartridge - 92 mm x 50 mm x 15 mm (3 5/8 in x 2 in x 5/8 in)
Bottles/Tubes - anything under 50 mm (2 in) Diameter will fit

If your printer is good at bridging then you can skip the support material since it is only there to support the top of the drawer slot, it can get hard to remove, but just keep trying and you'll get it. (I found that a hammer and a sharp object help a lot.)

I hope you enjoy this design, this was just supposed to be a personal project but friends that I made some of these for said I should post it, so here I am!

If you want to email me for a slight deviation of the design or just need some help with your own projects email me at [email protected]
(Note: this email is one that I check regularly, however, it also gets crowded so I will go ahead and apologize here if I don't see your emai