She-Ra - Forearms

She-Ra Princess of Power Forearms - not so great, but useful. When printed-out it's hard to mask the sealing, so I would recommend to use the provided source blend file and print it without the ornament - this way it will be much easier to finish the surface after gluing together.

The locking mechanism is actually quite complicated and needs wire to be put through holes of the sides - it gives enough strength, but quite tight to put a wire through so worth a redesigning to something less-demanding.

Inside you can find a number of hangs which can be used to sew a dumping pillows, but it's working quite well without them too.

**Note**: don't worry about the flat parts on the bottom parts of the model - just rotate them 180d by Y axis (to face it to the table) and print as usual. It will not be seen on the actual print. For curious - it's the blender did not processed the cutting properly due to complicated mesh.

The other items of She-Ra set:
* Tiara: https://www.thingiverse