Thingiverse
Shearwater Nerd2 Screen Cover
von henryci
2
Downloads
3
Likes
0
Makes
I lost the little cap that came with my Nerd2, so I made another one. Now, you can have one too!
This one is intended for hard plastics (I recommend PETG or ABS). And is retained by a simple bungee. It is possible to use this with TPU and avoid the bungee but I think another model would serve that better.
As with everything that gets wet, I recommend 100% infill to avoid collecting stagnant water in air pockets inside the print.
This one is intended for hard plastics (I recommend PETG or ABS). And is retained by a simple bungee. It is possible to use this with TPU and avoid the bungee but I think another model would serve that better.
As with everything that gets wet, I recommend 100% infill to avoid collecting stagnant water in air pockets inside the print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
