Shed Jet Blastoff

Get ready for a backyard blastoff! The Shed Jet Blastoff is a go!

Refining my sculpting trend of creating figures based on the old Weird-Ohs model kits and
CGI cartoon, I figure it was time to get into more vehicle creation and exaggerated set pieces (i.e. the bloated shed).

Please ignored the feet in the printed model pictures above; the supports broke off around them. The problem has since been fixed. The separation between the top smoke plume and shed roof is meant to look jagged to represent broken wooden planks from the "explosion".

If you have time, please visit my Facebook page to see all of my 3D sculpts and prints:
https://www.facebook.com/ScenestruckArt

Notes:

Due to the intended size, this model is ideal for FDM printing, not SLA. Resin print at your own discretion.

The shed is printed at 3-5% infill, and the figure at 15%.

Careful removing supports around the figure. Small parts may snap off.

Any warning from slicers involving "not watertight" or