Sheetmetal Transition - Rectangular/Square to Round

This was part of an old university project to produce a development of a Sheetmetal transition from a Rectangular/Square section to a Circular Section. More detail: - When you open the model, you will be prompted top open either the "generic" (formed) model, or the flat_pattern_state. - There are two sketches which define either the rectangular/square section and the circular section (depending on what values you put of course). - The part is currently symmetric, but you can can delete the constraints in the model inside the sketch and you should be able to make "offsets" for the transition. - The model was done in one half rather than a whole, so to get a whole model, just mirror the part. If you have any questions, feel free to ask.