Shelf assembly bracket for free-standing shelf

Corner bracket for a free-standing wire shelf with round steel legs that was in my basement, not sure on brand (closetmaid?) but I will add some pictures. After the original exploded from being overloaded I measured one with calipers and created a replacement model. Printed as 100% infill PLA on X1C but you can certainly get away with less if you aren't maxing out the shelf weight. If going heavier ABS or nylon would be recommended. Supports for the screwhead recess are optional, it prints fairly well without them but there will be a few stray strands that will get covered up by the screw itself. Recess itself is optional and can be remixed to remove.