Thingiverse
Shelf Bracket for Cubicle Wall
von Tempest1
12
Downloads
11
Likes
0
Makes
Decided to design a shelf for my cubicle office wall. Just placed a nice looking wood plank over the top and was all done.
They are offset to allow for fitting in the corners of spaces so make sure you pick the correct one when printing.
Used a Voxelab Aquila which is an ender 3 clone so settings should work and sliced it in Cura. See notes below about supports.
They are offset to allow for fitting in the corners of spaces so make sure you pick the correct one when printing.
Used a Voxelab Aquila which is an ender 3 clone so settings should work and sliced it in Cura. See notes below about supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
