Thingiverse
Shelf Brackets for 6mm Sheets
par 87squirrels
11
Téléchargements
6
Likes
0
Makes
- most likely not very usefull for anybody, but maybe the models can serve as inspiration :-D
- as an addition for my printer enclosure, consisting of 4 upright 20x20 profiles with acrylic in between
- I added a 6mm thick shelf in the back for spool holders, to get the weight away from my prusa i3 mk2
- 2 "LongSideHolder" parts in the back, containing the 20x20 profile offset
- 2 "ShortSideHolder" parts, one mirrored, for each side, and to prevent the shelf from sliding out
- my enclosure door is held in place with 6 pairs of 6mm magnets and sits on the bottom of the enclosure. It was quite fiddely to get in place due to the small area the panel sits on
- 2 "Door_Guide" parts, one mirrored, for each side, help the door panel to slide in place
- as an addition for my printer enclosure, consisting of 4 upright 20x20 profiles with acrylic in between
- I added a 6mm thick shelf in the back for spool holders, to get the weight away from my prusa i3 mk2
- 2 "LongSideHolder" parts in the back, containing the 20x20 profile offset
- 2 "ShortSideHolder" parts, one mirrored, for each side, and to prevent the shelf from sliding out
- my enclosure door is held in place with 6 pairs of 6mm magnets and sits on the bottom of the enclosure. It was quite fiddely to get in place due to the small area the panel sits on
- 2 "Door_Guide" parts, one mirrored, for each side, help the door panel to slide in place
87squirrels publie également sur
17 modèles supplémentaires sur 2 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
