Thingiverse
Shelf Holder
por Frozti
35
Descargas
22
Likes
0
Makes
This is a simple but strong shelf holder, very easy to print. No screws required. Peg diameter is 5.5mm and length is 17mm. If size is not right for you then adjust and upload as a remix for others to use or check remixes. You could also scaled the entire size in your slicer, if you don't mind the support being smaller as well.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
