Thingiverse
Shelf necklace holder
von nickydoyl
3
Downloads
11
Likes
0
Makes
This is a shelf attachment to allow you to hang necklaces from the end of a shelf.
Printed with 10% infill and support for all over 70 degrees.
This part is designed to hold 6mm x 3mm molybdenum magnets to allow a printed part to fit on top for earrings that can be removed individually (not designed)
Printed with 10% infill and support for all over 70 degrees.
This part is designed to hold 6mm x 3mm molybdenum magnets to allow a printed part to fit on top for earrings that can be removed individually (not designed)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
