Thingiverse
Shelf Regulator
by lcortese
4
Downloads
1
Likes
0
Makes
I did this design to help to level Shelf, it should be helpfull to nivelate o compensate a bad support.
Features:
* The Nut can be printed in a one piece.
* Dont need support, it is included into the same design, after print you need to break the little supports turning the regulator.
* Regulator increase the length until 14mm.
Try the design, comment your feedback, and enjoy it!
Features:
* The Nut can be printed in a one piece.
* Dont need support, it is included into the same design, after print you need to break the little supports turning the regulator.
* Regulator increase the length until 14mm.
Try the design, comment your feedback, and enjoy it!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
