Thingiverse
Electronics
Go to Model
Shelly Dimmer Case
277
Downloads
107
Likes
1
Makes
Known Issues:
-The holes are 5mm and the pegs are 4mm, this is because my printer has loose tolerances. If you want the box to actually "snap" together, you'll need to increase the size of the pegs. I just used glue once it was all wired.
-There should probably be some strain relief on the L wire coming out of the dimmer.
-The holes are 5mm and the pegs are 4mm, this is because my printer has loose tolerances. If you want the box to actually "snap" together, you'll need to increase the size of the pegs. I just used glue once it was all wired.
-There should probably be some strain relief on the L wire coming out of the dimmer.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
