Shiba Inu keycap

Cute little shiba inu plushie rendered into a keycap.

The bottom side of the keycap was designed as such due to the way my keyboard was built. With this design, it is necessary to support the print on the bottom side as the way I printed was always to keep the face upwards so that the face remains clear and smooth.

I personally printed at 0.2mm but anything less than that would work too.
I also experimented with the infill and found that it is possible to print with 0% infill with no compromise to the structural integrity of the cap.
Therefore, if not painting, I suggest using 0% infill for max light penetration.