Thingiverse
Shims (imperial)
von MarcElbichon
24
Downloads
11
Likes
0
Makes
Simple shims inspired by Handi-Shim ones : 1/32 , 1/16, 1/8 and 1/4
Each shim is 1/2 width and 1¼ deep and and the countersunk hole is for #8 screws
Tune yout first layer height to get the correct final height
Ex: 1/4 = 6.35 mm, so first layer 0.15 and other layers to 0.2 will get
I got best result upside down, to face the number to the bed
Do some tries and check height before printing a batch !
Conversions :
- 1/4 = 6,35mm
- 1/8 = 3,175mm
- 1/16 = 1,5875mm
- 1/32 = 0,79375mm
Each shim is 1/2 width and 1¼ deep and and the countersunk hole is for #8 screws
Tune yout first layer height to get the correct final height
Ex: 1/4 = 6.35 mm, so first layer 0.15 and other layers to 0.2 will get
I got best result upside down, to face the number to the bed
Do some tries and check height before printing a batch !
Conversions :
- 1/4 = 6,35mm
- 1/8 = 3,175mm
- 1/16 = 1,5875mm
- 1/32 = 0,79375mm
MarcElbichon veröffentlicht auch auf
77 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
