Thingiverse
Shinto Rasp handle
3
Downloads
5
Likes
0
Makes
This is a handle for a shinto rasp. The blades are frequently sold solo, and I bought one years ago without the handle, which was like two thirds of the cost! So, eventually buy a handle? FTIJPI!
Supports will help the handle be nice and circular, but aren't really necessary.
If your print bed is at least 150 mm, print two of the "Full Half" model, then glue/epoxy them together around the blade.
The "Mini" models are designed to be printable on a Monoprice Select Mini. Print two of the "top", side by side and head to foot, and one of the "base", standing on end. then epoxy a 5/16" dowel in to connect them.
Supports will help the handle be nice and circular, but aren't really necessary.
If your print bed is at least 150 mm, print two of the "Full Half" model, then glue/epoxy them together around the blade.
The "Mini" models are designed to be printable on a Monoprice Select Mini. Print two of the "top", side by side and head to foot, and one of the "base", standing on end. then epoxy a 5/16" dowel in to connect them.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
