Shogi Game Piece

Shogi game pieces, a little over the top...

I do not have a two filament printer, so this was printed using z-hop of 0.4 mm
Each piece is constructed of two parts - standard side and promoted side. These two sides are glued together with CA glue.

Parts were designed in Fusion360 and Cura used slice parts.

Each side of piece, is composed of three prints - white frame, character, body. I inserted all three pieces into Cura, aligned them then sliced each piece individually. Parts were printed without clearing build plate

To maximize clarity, I printed white frame piece first. Then color changed and printed character with z-hop on. Then finished piece in white. This was done for both sides.