Thingiverse
Shogun Battlemech
von UnrestedGuy
69
Downloads
33
Likes
0
Makes
My take on Battletech's Shogun Battlemech
Contains both .blend and .stl files for Shogun 2F and 2H (I can add 2E but it's basically the same as the 2F). Blend files are recommended so you can remove the hexbase if needed for scaling or to customise the pose.
I use a resin printer so I do not know how well it will work if a filament printer is used, but always make sure parts are supported. For a resin printer you can print it on a slight angle or on it's back __on a platform__ to allow for drainage out of the hexbase.
You can request in the comments if you want me to make a specific battletech miniature (although there is no timeline on when it will be completed)
Contains both .blend and .stl files for Shogun 2F and 2H (I can add 2E but it's basically the same as the 2F). Blend files are recommended so you can remove the hexbase if needed for scaling or to customise the pose.
I use a resin printer so I do not know how well it will work if a filament printer is used, but always make sure parts are supported. For a resin printer you can print it on a slight angle or on it's back __on a platform__ to allow for drainage out of the hexbase.
You can request in the comments if you want me to make a specific battletech miniature (although there is no timeline on when it will be completed)
UnrestedGuy veröffentlicht auch auf
18 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
