Thingiverse
Shooting Headphones
door Taskino
11
Downloads
7
Likes
0
Makes
Hi
I noticed that after some time of non-use of the headphones for shooting, the material that must adhere well in the area of the ears was slightly compressed, to avoid further damage to the material, I designed a spacer for headphones in order to keep open just enough so as not to send in compression the material.
I made a hole in the center of Ø6.5mm so that I could eventually mount it on the wall.
For wall mounting I recommend adding a piece of pipe so that the piece is detached from the wall.
I hope it will help you to not ruin the headphones.
If you will also need the 3D model to distance it from the wall let me know.
I noticed that after some time of non-use of the headphones for shooting, the material that must adhere well in the area of the ears was slightly compressed, to avoid further damage to the material, I designed a spacer for headphones in order to keep open just enough so as not to send in compression the material.
I made a hole in the center of Ø6.5mm so that I could eventually mount it on the wall.
For wall mounting I recommend adding a piece of pipe so that the piece is detached from the wall.
I hope it will help you to not ruin the headphones.
If you will also need the 3D model to distance it from the wall let me know.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
