Thingiverse
ShopVac Adapter
por demoman2020
5
Descargas
4
Likes
0
Makes
Needed an adapter for my short hosed shop-vac. Also the end of the vac just could not make it into the tight spaced. So modeled an adapter in Fusion360.
Large End: 31.75mm Inner Diameter
Small End: 6.5mm Inner Diameter
Was just right to fit snug to the shop-vac hose, and place a run of clear plastic tube in the adapter. Cut the plastic tube so there was sufficient air flow from the shop vac.
Printed out well and the plastic tubing has been able to fit in all of the rails as well as into the smaller spots I wished to clear.
Update 07/26/20: Added 3 version of the Design. One the original, one rotated, and one that I printed with my Ender5.
Large End: 31.75mm Inner Diameter
Small End: 6.5mm Inner Diameter
Was just right to fit snug to the shop-vac hose, and place a run of clear plastic tube in the adapter. Cut the plastic tube so there was sufficient air flow from the shop vac.
Printed out well and the plastic tubing has been able to fit in all of the rails as well as into the smaller spots I wished to clear.
Update 07/26/20: Added 3 version of the Design. One the original, one rotated, and one that I printed with my Ender5.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
