Thingiverse
Shore Aggressor
von Delta_Makes
112
Downloads
77
Likes
1
Makes
This is a 28mm scale Coastal/River boat intended for use with the Konflikt 47 game system, but do whatever.
EDIT: I've uploaded a larger turret with a bigger gun, this is meant to upgrade the middle gun. I know it will not fit in the rear gun placement.
I've labeled it as a WIP because I haven't done any final test prints yet. I'll remove the WIP status when I do and find everything to be satisfactory.
Print with supports (should be easy to remove, I made sure of that), otherwise, I'm unsure if any particular print settings are required, I print at .1 layer height and it works just fine.
The open space towards the rear is for an anti-air mount.
This is my own personal design, but I drew heavy inspirations from the Bronokater Soviet Armoured Patrol Boat
EDIT: I've uploaded a larger turret with a bigger gun, this is meant to upgrade the middle gun. I know it will not fit in the rear gun placement.
I've labeled it as a WIP because I haven't done any final test prints yet. I'll remove the WIP status when I do and find everything to be satisfactory.
Print with supports (should be easy to remove, I made sure of that), otherwise, I'm unsure if any particular print settings are required, I print at .1 layer height and it works just fine.
The open space towards the rear is for an anti-air mount.
This is my own personal design, but I drew heavy inspirations from the Bronokater Soviet Armoured Patrol Boat
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
